900 MM - 1200 MM INCLINED AXIS MULTIPLE BLOCK SENSOR ARM SPEED SYNCHRONISED STEEL WIRE DRAWING MACHI
MKS INCLIED BLOCK DRY DRAWING MACHINES:
MKS multiple block drawing machines have inclined axis drawing blocks and dancer arm speed synchronization recommend the MKS for the high-speed drawing of medium and fine-diameter wire.
The bench framework, built in sturdy, electro welded plate steel, comes in one or more multiple-block section fitted with eyebolts to facilitate lifting, transport and installation. The capstan and relative die box, motors,brakes, safety guards, water feed drainage tubes etc. Are all pre-assembled on the bench.
All electrical, electro-mechanical and electronic components come from leading suppliers and are available world wide.
The operating logic is achived through a PLC , with an automatic diagnostic system.
The drawing blocks are made from hot anealed steel cast. Capstan pulling bands plasma hot coated with a tick layer of thungsten carbide are available.
Cooling water is fed to the drawing blocks and dies through two seperate circuits.
A pneumatic brake installed on each block to serve both as a parking brake and emergency brake.
Electrical safety switches make sure the machine can not be run if safety guards are open.
Each drawing block is driven by an IP55 A.C. motor, controlled by a driver . The motors have force cooling , thus available to good cool performance.
The reduction gears theoretical lifespan of 85.000 working hours.
TYPE : MKS 1200 Max.Inlet Diameter (mm) : 15 - 8 mm