550 MM - 710 MM INCLINED AXIS MULTIPLE BLOCK SENSOR ARM




MKS INCLIED BLOCK DRY DRAWING MACHINES

MKS multiple – block drawing machines have inclined axis drawing blocks and dancer arm speed synchronization recommend the MKS for the high-speed drawing of medium and fine-diameter wire.

CONSTRUCTION

The bench framework, built in sturdy, electro welded plate steel, comes in one or more multiple-block section fitted with eyebolts to facilitate lifting, transport and installation.

 The capstan and relative die box, motors ,brakes, safety guards, water feed drainage tubes etc. Are all pre-assembled on the bench.

ELECTRICAL EQUIPMENTS

 All electrical, electro-mechanical and electronic components come from leading suppliers and are available world wide. The operating logic is achived through a PLC , with an automatic diagnostic system.

DRAWING BLOCKS

The drawing blocks are made steel cast. Capstan pulling bands plasma hot –coated with a tick layer of thungsten carbide are available.

 COOLING

Cooling water is fed to the drawing blocks and dies through two seperate circuits.

SAFETY

A pneumatic brake installed on each block to serve both as a parking brake and emergency brake. Electrical safety switches make sure the machine can not be run if safety guards are open.

 MOTORIZATION

Each drawing block is driven by an IP55 A.C. motor, controlled by a driver .

The motors have force cooling , thus available to good cool performance. The reduction gears theoretical lifespan of 85.000 working hours.

 

TECHNICAL SPECIFICATIONS:

Carbon  : low , medium , high

Blocks NO : 3 -14

Block Dia.  : 550 mm – 710 mm

Inlet wire Dia. : 8.0 mm   Max

Outlet Wire Dia. : 1.3 mm  Min

 

Note   : Both dies and Cassettes can be used in this machine .

 

Machine photos